Author Topic: D & E CAMS  (Read 2574 times)

  • Guest
D & E CAMS
« on: February 05, 2010, 08:33:12 PM »
Finally got around to cutting the cams for my D&E GG. It actually went quite well. Took about an hour to cut one cam doing the advance one hole on the dividing head and .005 on the table and plunge. I was very pleased with the results. We will cut the other three cams ( my friend and I are builting two guns ) tomorrow unless he can\'t get here because of the snow. I will post a couple of pictures of the set up and actual cutting when we are done.

Offline Dave

  • Site Admin
  • Administrator
  • Hero Member
  • *****
  • Posts: 859
D & E CAMS
« Reply #1 on: February 06, 2010, 01:35:33 PM »
Pictures of your progress would be great!!! I want to build a D&E gun someday...

  • Guest
D & E CAMS
« Reply #2 on: December 21, 2010, 08:00:57 PM »
The cams are the one part (well two actually) that I wasn\'t happy with when I made them.  I decided to get the rest of the gun made before I remade the cams again.