Gatlinggunforum
General Category => Gunsmithing/Kit builds => Topic started by: Dave on January 23, 2014, 07:14:12 PM
-
I have a old wore out Ruger Mark 1, I bought a Wolf spring kit, a new firing pin and retainer to try and renew it. So I decided to try and make a aluminum barrel for it. The body is 6061 1 inch od and 3/4 id aluminum tube. The actual barrel is 6061 3/4 aluminum rod. The barrel will be around 7 inches long ,drilled and sleeved with a steel barrel liner...
Im going to try and have it done next week. Ready for powder coating anyway...
[attachment=3]gun1.jpg[/attachment]
[attachment=2]gun2.jpg[/attachment]
[attachment=1]gun3.jpg[/attachment]
[attachment=0]gun4.jpg[/attachment]
-
I had a mark 1 in the 80s, my ex wife took it.
GREAT job Dave
-
Dave,
Did you get a Tormach 1100?
nitewatchman
-
I got a 770, wish I would have got the 1100 :evil:
-
Here it is, ready for sandblasting and cerakote... I going to build a muzzle brake to (theres a cap on it now) Seems to shoot good... I put a little stiffer recoil spring in it also.
-
Very nice job Dave.
bruski
-
You said that it shoots good.
Well it sure looks good also. Nice Job.
Later 42rocker