« previous next »
Pages: [1]

Author Topic: Hinge pin mounting for stick magazine base  (Read 758 times)

Offline Larryx

  • Full Member
  • ***
  • Posts: 105
Hinge pin mounting for stick magazine base
« on: August 17, 2020, 07:49:14 PM »

I looked and looked and looked  on drawing  48-23 for the second hinge pin block for the magazine base, but was unable to locate that feature. I need help on this one please!


Logged

Offline Swarfmonger

  • Newbie
  • *
  • Posts: 39
Hinge pin mounting for stick magazine base
« Reply #1 on: August 17, 2020, 08:59:18 PM »
The second hinge is a hole drilled into the front of the right hand breech casing side rail.
Logged

Offline Larryx

  • Full Member
  • ***
  • Posts: 105
Hinge pin mounting for stick magazine base
« Reply #2 on: August 17, 2020, 09:28:26 PM »
thank you. That appeared to be a logical place to put the aft end but is this shown on any of the prints? I looked at the print showing the side rail but unless I missed it, that print is silent in that regard.
Logged
Pages: [1]
« previous next »