« previous next »
Pages: [1]

Author Topic: Small surface grinder  (Read 1011 times)

Offline Dave

  • Site Admin
  • Administrator
  • Hero Member
  • *****
  • Posts: 859
Small surface grinder
« on: February 05, 2019, 06:12:41 PM »

I added a Enco 6 by 12 surface grinder to my shop. I sure wish I would have done this (cheap) addition way sooner. I was told it had only a few hours on it. I took a few pieces off to clean it, looked good on the bottom sides!  It sure makes a neat finish on parts! I can think of a lot of uses for this machine. Came with the magnetic chuck too


 


Last pic is just a test part, before I got the diamond dresser for the wheel.

« Last Edit: February 05, 2019, 06:13:55 PM by Dave »
Logged

Offline maccrazy2

  • Full Member
  • ***
  • Posts: 229
Small surface grinder
« Reply #1 on: February 06, 2019, 12:11:25 AM »
I’ve been wanting one for years but I just can’t justify the floor space. If I ever move and get to build a shop from the ground up, perhaps then.
Logged
Pages: [1]
« previous next »