Gatlinggunforum

General Category => Equipment => Topic started by: dunn6902 on March 04, 2020, 11:51:30 PM

Title: Replacing A Grizzly 0705 Mill Collet Locking Screw
Post by: dunn6902 on March 04, 2020, 11:51:30 PM

I broke off the tip off the collet locking screw on my new mill and needed to figure out a way to replace it. According to Grizzly It was only possible by taking quite a bit apart. I wasn\'t doing that so I had to figure out a better way. If it happened to me it might happen to someone else.