« previous next »
Pages: [1]

Author Topic: SX3 Conversion  (Read 2322 times)

  • Guest
SX3 Conversion
« on: December 21, 2011, 08:19:22 PM »
Here is my SX3 Fusion conversion.

No turning back now! :o





Removed the table, saddle, and the Z axis drive and lead screw. Ready for the Ball screws and mounts.

Matt
Logged

  • Guest
SX3 Conversion
« Reply #1 on: December 21, 2011, 08:28:01 PM »
Here is the Soigeneris control box.


A shot of the G540


Inside houses the MeanWell 320W 48V Power Supply with its own fan.


This control box is built like a tank. I am tickled pink with the craftsmanship of the entire controller.

Matt
Logged

  • Guest
SX3 Conversion
« Reply #2 on: December 21, 2011, 08:29:51 PM »
Here we got the 20 AWG stepper motor cables with the db9\'s attached.


A db9 connector rigged up for 2 external E-stops, 1 by the Mill, and 1 by the Lathe.


A 3K resistor for the Nema 34.


Some limit switches.


Matt
Logged

  • Guest
SX3 Conversion
« Reply #3 on: December 21, 2011, 08:31:42 PM »
Being the computer is placed in between the two machines, I got something that\'s a bit more mobile than the key board for jogging.



Matt
Logged

  • Guest
SX3 Conversion
« Reply #4 on: December 21, 2011, 08:33:41 PM »
Got a few things soldered and wired up today anyway.





Matt
Logged

  • Guest
SX3 Conversion
« Reply #5 on: December 21, 2011, 08:40:39 PM »
Some progress:

The Z ballscrew









Matt
Logged

  • Guest
SX3 Conversion
« Reply #6 on: December 21, 2011, 08:42:56 PM »
X and Y





Matt
Logged

  • Guest
SX3 Conversion
« Reply #7 on: December 21, 2011, 08:52:11 PM »
Here is the mill making some loco parts with videos
Made a milling jig

Milling video





Machining Video






Matt
Logged
Pages: [1]
« previous next »