« previous next »
Pages: 1 [2]

Author Topic: Hard bolt cocking force  (Read 2546 times)

Offline barrelguy

  • Newbie
  • *
  • Posts: 12
Re: Hard bolt cocking force
« Reply #20 on: December 12, 2020, 06:06:19 PM »
Cutter, all comments are worth considering.  If the .925 dim. to centerline of the cam path is correct I should be ok.  I cut the path on a Sip Jigbore
with .00005 resolution.
Logged

Offline Cutter

  • Hero Member
  • *****
  • Posts: 1174
Re: Hard bolt cocking force
« Reply #21 on: December 13, 2020, 12:46:42 PM »
Sorry
I should have stated  radial tolerance , not linear.
Logged

Offline barrelguy

  • Newbie
  • *
  • Posts: 12
Re: Hard bolt cocking force
« Reply #22 on: December 14, 2020, 04:52:06 PM »
Further testing proved me to be wrong.  Once the ball bearings failed and I used the bronze rollers I am about back to where I started from.
Rev. E is increase the crank handle length from 4.625 to 8.000.  Oh, well, I tried.  It sure seemed to be a good idea at the time.
« Last Edit: December 14, 2020, 04:58:22 PM by barrelguy »
Logged
Pages: 1 [2]
« previous next »