Jump to content


Replacing A Grizzly 0705 Mill Collet Locking Screw

  • Please log in to reply
No replies to this topic

#1 dunn6902



  • Members
  • PipPip
  • 16 posts

Posted 05 March 2020 - 04:51 AM

I broke off the tip off the collet locking screw on my new mill and needed to figure out a way to replace it. According to Grizzly It was only possible by taking quite a bit apart. I wasn't doing that so I had to figure out a better way. If it happened to me it might happen to someone else.

Attached Files

  • Cutter likes this

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users