Jump to content


Photo

Small surface grinder


  • Please log in to reply
1 reply to this topic

#1 Dave

Dave

    Site Admin

  • Administrators
  • 784 posts
  • LocationIllinois

Posted 05 February 2019 - 11:12 PM

I added a Enco 6 by 12 surface grinder to my shop. I sure wish I would have done this (cheap) addition way sooner. I was told it had only a few hours on it. I took a few pieces off to clean it, looked good on the bottom sides!  It sure makes a neat finish on parts! I can think of a lot of uses for this machine. Came with the magnetic chuck too

 

Last pic is just a test part, before I got the diamond dresser for the wheel.

Attached Files


  • bruski, Sparky_NY, Roller and 1 other like this

#2 maccrazy2

maccrazy2

    Advanced Member

  • Members
  • PipPipPip
  • 75 posts

Posted 06 February 2019 - 05:11 AM

I’ve been wanting one for years but I just can’t justify the floor space. If I ever move and get to build a shop from the ground up, perhaps then.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users