Jump to content


Photo

NEW HERE AND ALREADY QUESTIONS


  • Please log in to reply
3 replies to this topic

#1 smittyoutdoors

smittyoutdoors

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 11 October 2012 - 08:26 PM

HELLO I just recieved plans and started building a few piecies. So far side rails,1 piece front bow complete,I have the carrier block,front and rear barrel plates and recoil plate off the lathe and ready for the mill. Alot more to this than i first thought. Heres a couple questions hopefully someone can help with,1 st where are the 4-40 holes located that hold the breech casing and box cam together? 2nd does any one have the cutter path just "Y" and "X" for the decagon on the carrier ? also the box cam I thought I could come down in "Z" to -1.438 and move towards center in"y" move 1.175 in "x" and out in "y" lookig down from spindle on turn table standing up with part 90 from spindle "X" 0 breech end "Y" o CL of 2.875 dia. mill 1 side turn 180 mill other path this is on a 3 axis cnc bridgeport

thanks markus

#2 Cutter

Cutter

    Advanced Member

  • Members
  • PipPipPip
  • 848 posts

Posted 13 October 2012 - 01:58 AM

Here's the code for a .500 end mill

 

Attached File  nc file-id=1018.zip   526bytes   3 downloads



#3 smittyoutdoors

smittyoutdoors

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 13 October 2012 - 02:31 AM

thank you ill give it a try in the am

#4 Cutter

Cutter

    Advanced Member

  • Members
  • PipPipPip
  • 848 posts

Posted 13 October 2012 - 03:26 PM

Markus,
I don't fully understand your strategy for milling the Cam.
So here's a 3D .IGS file, that can be cut with your 3 axis mill .




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users