Jump to content


Photo

D&E gatling gun 22 LR


  • Please log in to reply
6 replies to this topic

#1 Pmercer

Pmercer

    Advanced Member

  • Members
  • PipPipPip
  • 121 posts

Posted 26 September 2012 - 10:40 AM

The imperial measurementss are for 22 short.
I've converted all measurements to metric, and then where a modification is needed for LR, I've marked it on as such:

2.377 60.37mm > 80.2mm LR

2.377 is original imperial
60.37mm is the metric conversion
80.2mm LR is the measurement needed for LR.

If LR is not shown, then the change is due to something else, ie, the imperial measurement might convert to 9.5mm, but I'll be putting a metric thread onto the bar, so the bar needs to be 10mm, not 9.5mm.

#2 Pmercer

Pmercer

    Advanced Member

  • Members
  • PipPipPip
  • 121 posts

Posted 26 September 2012 - 10:45 AM

more

#3 kulcherschock

kulcherschock

    Member

  • Members
  • PipPip
  • 10 posts

Posted 24 November 2012 - 12:50 AM

i was wondering why soldered body outside diameter need enlarged

#4 Pmercer

Pmercer

    Advanced Member

  • Members
  • PipPipPip
  • 121 posts

Posted 24 November 2012 - 07:28 PM

I'm not sure it has been. The original measurements are imperial. I've added measurements in metric above/next to it. Where I've modified the measurement I've written something like >3mm LR.

If you look at the diagram Firing Pin Retainer, you'll see I've adjusted a measurement to 3mm.

Hope this helps.

#5 kulcherschock

kulcherschock

    Member

  • Members
  • PipPip
  • 10 posts

Posted 01 December 2012 - 07:31 PM

i was looking at diagram soldered body where it says 60.325mm>63.9mm .

#6 Pmercer

Pmercer

    Advanced Member

  • Members
  • PipPipPip
  • 121 posts

Posted 18 December 2012 - 11:00 AM

I've just seen your reply so sorry about the delay in replying. Ive not made the body yet so can't recall why I changed that dimension or if it's a typo. I'll have to check the CAD. I'll do that ASAP to get an answer. It's the CAD that I have been working from mainly.

#7 Pmercer

Pmercer

    Advanced Member

  • Members
  • PipPipPip
  • 121 posts

Posted 20 October 2013 - 10:14 PM

I forgot to update this. I think I changed that dimension because I changed the way that i screwed the rear cap cap onto it. I wanted more material thickness




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users