Jump to content


Photo

Engines that run on gas.


  • Please log in to reply
5 replies to this topic

#1 bruski

bruski

    Advanced Member

  • Members
  • PipPipPip
  • 302 posts
  • LocationARIZONA

Posted 19 March 2012 - 02:38 AM

Here are a few of the engines that I made in the past. They all run on gas and some are glow plug fired and the others are ignition fired.
bruski

#2 Cutter

Cutter

    Advanced Member

  • Members
  • PipPipPip
  • 744 posts

Posted 19 March 2012 - 03:33 PM

Very nice Bruski,
A lot of time in those projects.

#3 bruski

bruski

    Advanced Member

  • Members
  • PipPipPip
  • 302 posts
  • LocationARIZONA

Posted 20 March 2012 - 06:45 PM

Many hours without any cnc equipment and single at the time.
bruski

#4 Cutter

Cutter

    Advanced Member

  • Members
  • PipPipPip
  • 744 posts

Posted 20 March 2012 - 06:58 PM

Bruski,
Are these sand castings ?
And, did you make the patterns ?
What other materials can you cast ?
Cutter

#5 bruski

bruski

    Advanced Member

  • Members
  • PipPipPip
  • 302 posts
  • LocationARIZONA

Posted 20 March 2012 - 10:31 PM

Cutter, all of the chevy parts were machined from bar stock including the oil pan and valve covers. The chevy blocks started as 3 X 3 X 5 inch block of aluminum and then machined away everything that didn't look like a chevy small block. I had some drawings for the 1/4 scale chevy.
The Ford flat head engine (The Challenger) was made up of some castings for the heads, distributor housing, water pump and the block. Castings are available from Coles Power models. Then the camshaft, crankshaft and rods were all machined from bar stock.
bruski

#6 42rocker

42rocker

    Advanced Member

  • Members
  • PipPipPip
  • 253 posts
  • LocationFla

Posted 15 December 2013 - 02:29 AM

Simple one word -- WOW!!

Very very nice.

Later 42rocker




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users